Store Front Account Search Product List Basket Contents Checkout
Sign In

EZ STORE SEARCH:


APPAREL
AUDIO & ENTERTAINMENT
BOOKS & SERVICE MANUALS
BRAKES
CHROME & DRESS UP
A/C & COOLING SYSTEM
DECALS
DIFFERENTIAL & REAR END
   AXLE SHAFTS
   CARRIERS AND DIFFERENTIALS
   DRIVESHAFTS
   RING & PINIONS
   COVERS
EFI PARTS
ELECTRICAL
EMMISION COMPONENTS
ENGINE & FUEL RAIL COVERS
ENGINE COMPONENTS
EXHAUST
EXTERIOR ACCESSORIES
FLUIDS, EPOXIES AND SEALANT
FRONT ACCESSORY BELT DRIVE
GAUGES
GIFTS, NOVELTIES AND MEMORABELIA
HAND HELD PROGRAMMERS
HOSES
IGNITION
INTAKE & DUCTS
INTERIOR ACCESSORIES
KEY CHAINS
LSX SWAP PARTS
LT1 SWAP PARTS
MAINTENANCE
MODELS & DIECASTS
NITROUS OXIDE
SEARCH BY ENGINE TYPE
SEARCH BY MODEL
SERVICES
SUSPENSION AND CHASSIS
TRANSMISSION
TURBOS AND SUPERCHARGERS
WHEELS & TIRES
WIRING PRODUCTS
Z-MISC
TOOLS & EQUIPMENT
PAINT & COATINGS
NEW PARTS
LITERATURE & BOOKS
USED PARTS
HEAT PROTECTION
TRUCK ACCESSORIES
FABRICATION COMPONENTS
CARBURETORS
STEERING COLUMN
Vehicle Car Care
RACING
Safety and Security


U-Joint, 1310 (Standard/Greasable), 84-96 Corvette (F/R), 89-92 Camaro/Trans Am w/ 1LE (Front), Prec
 
U-Joint, 1310 (Standard/Greasable), 84-96 Corvette (F/R), 89-92 Camaro/Trans Am w/ 1LE (Front), Prec Quantity in Basket: None
Code: PRE-369
Price: $14.48
Shipping Weight: 1.00 pounds
 
 
Quantity:
 
New Moog/Precision u-joint.  This u-joint fits the front (transmission yoke) on aluminum driveshafts only.   This is a stock replacement, greasable u-joint, which uses outside snap rings.  The u-joint caps are 1.063" in diameter, and the u-joint width is 3.2" on all crosses (1310 series).  These joints only work with factory driveshafts and rear ends.  These are not compatible with an aftermarket rear as performance aftermarket rears typically use a different series u-joint at the pinion yoke. Sold individually.  Fits the following:

89-92 Camaro w/ Factory 1LE aluminum shaft
89-92 Firebird/Trans Am w/ Factory 1LE aluminum shaft
89 Turbo Trans Am
84-96 Corvette

NOTE : U-joints will require either a hand press or vice to install.  To prevent damage during installation, make sure the needle bearings to not fall or move during installation. 

HOME   ONLINE STORE   PRODUCT LINES   TRANSIT TIMES   POLICIES   CONTACT US  

Acceptable payment methods