84-96 Corvette Differential Driveshaft Prop Shaft U-Joint STANDARD GREASABLE

Quantity:

close

Code: MOO-369-1

Price: $12.70

Shipping Weight: 0.88 pounds

2 available for immediate delivery

Quantity in Basket: None

New Moog/Precision u-joint. This u-joint fits both the front (transmission yoke) and rear (differential yoke) u-joints, but only for the driveshaft (not the half shafts). This is a stock replacement, greasable u-joint, which uses outside snap rings. The u-joint caps are 1.063" in diameter, and the u-joint width is 3.2" on all crosses (1310 series). These joints only work with factory driveshafts and rear ends. These are not compatible with an aftermarket rear as performance aftermarket rears typically use a different series u-joint at the pinion yoke. Sold individually. Fits the following:

84-96 Corvette (all models)

NOTE : U-joints will require either a hand press or vice to install. To prevent damage during installation, make sure the needle bearings to not fall or move during installation.